Is it normal for belts to shred like this? - Bambu Lab X1 Series

I see little bits of belt have shredded off one of the main belts. Is this normal? Should I do anything about it?

Bambu Lab X1 Carbon: Info & Discussion (SRO) - Esk8 Electronics - esk8.news: DIY Electric Skateboard Forums

Bambu Lab X1 Carbon Review: Living In The Future

Is it normal for belts to shred like this? - Bambu Lab X1 Series - Bambu Lab Community Forum

Banding / Ringing type artifacts? - #290 by adriangarside - Bambu Lab X1-Carbon - Bambu Lab Community Forum

AMS stacking stand for P1P and X1 by MihaiDesigns - MakerWorld

hepa and carbon air filter for bambu lab Remixed by riccardolisci - MakerWorld

Persistent 2mm VFAs on X-axis - Troubleshooting - Bambu Lab Community Forum

AnkerMake M5C 3D Printer, 500 mm/s High-Speed Printing, All-Metal Hotend, Supports 300℃ Printing, Control via Multi-Device, Intuitive, 7×7 Auto-Leveling, 220×220×250 mm Print Volume : Industrial & Scientific

Ringing and decline in surface quality - Troubleshooting - Bambu Lab Community Forum

Strange problem just developed! - Troubleshooting - Bambu Lab Community Forum

Bambu lab x1 squeaking wear on top belt : r/BambuLab

My Bambu sounds like War of the Worlds at the end of bed levelling. Is this normal : r/BambuLab