Input Shaper without effect?! - General Discussion - Klipper

Basic Information: Printer Model: Kingroon KP3S MCU / Printerboard: Kingroon KP3 V1.2 klippy.log klippy.log (20.1 KB) Describe your issue: Hi folks, although it says “Never change a running system” or something similar I changed the print head of this little fellow and swapped the RasPi 3 with an OrangePi Zero that was used on my CoreXY before. Before all this I think I found a good config in terms of input shaping. Due to changed mass of the print head I rerun resonance measurement

I love Klipper and input shaping! I'm never going back to Marlin

Klipper input shaper wierd graph - General Discussion - Klipper

FR] Input shapers support in Klipper · Issue #3025 · Klipper3d

Sovol SV07 Plus 3D Printer with Klipper Firmware, Max Print Speed

Creality Sonic Pad Based on Klipper Firmware, 7 Touch Screen 3D Printer Smart Pad with Higher

klipper: Backup, Input Shaper Graph, Diagnostics

Update on Original Prusa XL Shipping, Input Shaper Alpha for the

Input Shaping - General Discussion - Team FDM

Measuring Resonances - Klipper documentation

Klipper Tuning Guide - Get the Best Klipper experience on your Ender 3

Am I suppose to uncomment input shaper or is it set after running

Sovol SV07 Plus 3D Printer with Klipper Firmware, Max Print Speed

Input Shaper without effect?! - General Discussion - Klipper

The LDO input shaper toolkit provides all the necessary parts for performing Klipper input shaper calibration with minimal hassle. For detailed

LDO Input Shaper Toolkit (ADXL345) for Klipper